Friday, August 18, 2017

Carols of Christmas Project Sheet

The Carols of Christmas stamp set and framelits are in the 2017 Holiday Catalog which begins Sept. 1st. However, during August, you can order these 2 products early!! WooHoo!!


All images © 1990-2017 Stampin’ Up!®

Supplies:
  • Stamp Set Carols of Christmas (w-144801, c-144804)
  • Cardstock – Cherry Cobbler (119685), Very Vanilla (101650), Tranquil Tide (144246)
  • Stamp Pads – Cherry Cobbler (126966); Tranquil Tide (144085)
  • Misc. – 3/8” Metallic-Edge Ribbon Gold (144146), Fabulous Foil Designer Acetate (141653), SNAIL Adhesive (104331)
Measurements:
  • Cherry Cobbler: 8-1/2" x 5-1/2"
  • Tranquil Tide: 5-1/2” x 2-1/4”, 2-5/8” x 4-1/8”
  • Very Vanilla: 2-1/2” x 4”
  • Foil Acetate piece: 3” x 5-1/2”
  • Ribbon: 6-1/2” piece
Instructions:
  1. Fold Cherry Cobbler Cardstock in half to create card base.
  2. Using Cherry Cobbler ink, stamp “Deck the Halls” on Very Vanilla piece and layer onto Tranquil Tide mat piece.
  3. Using Cherry Cobbler ink, stamp small flower and small dots on each side of sentiment. Using Tranquil Tide ink, stamp 2 sets of leaves around flower on each side of sentiment.
  4. Using SNAIL, adhere the foil acetate to card base. Be sure to run your SNAIL in the middle of the piece so once you put the next layer on top, the SNAIL will not show through.
  5. Using SNAIL, attach ribbon to the long Tranquil Tide piece and attach to card base, on top of foil acetate.
  6. Attach stamped sentiment unit to card base.

If you would like to create this card, here's a list of the products you'll need to gather! If you click on the photos below, you will be directed to my online store: Shop with Debbie!

If you have any questions or would like to place an order, please email me and I will respond right away.

I appreciate each and every one of you and look forward to hearing from you.

Thanks for visiting and see you next time!


Tuesday, August 15, 2017

NEW Items Added to Clearance Rack - - Up to 60% off!!


If you are after a bargain, or missed an item in the last Spring/Summer catalog, then hop yourself over to the Clearance Rack right away.



THIS IS BIG!  The Stampin’ Up! Clearance Rack was JUST updated with oodles of additional products. Fabulous die sets, punches, holiday accessories, pretty paper, ribbon and more. Discounts up to 60% off.  Don’t delay. These discounted products sell quickly and are ONLY AVAILABLE WHILE SUPPLIES LAST!!

TIP:  There is a sort feature on the Clearance Rack page. The default is 'A-Z' so the items are listed alphabetically. If you'd like to see the most recent items added, click the Sort By button and choose 'Newest'. 

Thanks for stopping by,



Saturday, August 5, 2017

Carols of Christmas Early Release



Hey Stampers!  
Can you believe its already time to start thinking about your holiday cards and projects?  Stampin Up just announced the early release of the Carols of Christmas Bundle.  Yay!!  This early release started August 1st and will be featured in the Holiday Catalog on Sept. 1. Yay!!
The stamps and dies can be ordered individually or save 10% when you purchase the bundle.  And don’t forget, you can use any earned Bonus Days coupons to purchase the Carols of Christmas items (or your choice of products). 
Thanks for stopping by.  Let me know if you have any questions. I’m happy to help!! 
Inky Hugs, Debbie



Enjoy a few Carols of Christmas Samples!




Product List





Thursday, July 13, 2017

You Move Me Project Sheet

Have you noticed the You Move Me Stamp Set and Move Me Thinlits Bundle on page170 of the new catalog?

I have to admit, this is one I skimmed by at first. But, now that I've seen it in action, I am super excited about this bundle.

By slowly pulling the stamped image, the hummingbird wings appear to flutter!! A-M-A-Z-I-N-G!!

This also works with other images ... butterflies, dragonflies, wagging dog tail, moving elephant trunk ... the options are endless. I have posted a video below this tutorial so you can check it out.


You Move Me
All images © 1990-2017 Stampin’ Up!®
Supplies:
  • Stamp SetsYou Move Me (144002) or You Move Me Bundle (145322)
  • Card Stock – Peekaboo Peach (141417); Powder Pink (144244); Whisper White (100730); Petal Garden Designer Series Paper Stack (144168)
  • Stamp Pads – Pear Pizzazz (131180); Garden Green (126973); Old Olive (126953)
  • Misc. – Move Me Thinlits (143732); Big Shot (143263); 3/4" Circle Punch (119873); Layering Squares Framelits (141708); Tear & Tape Adhesive (138995); Multipurpose Liquid Glue (110755); Big Shot Die Brush (144262); Dimensionals (104430); wax paper
Measurements:
  • Peekaboo Peach: 5-1/2" x 8-1/2", scored at 2-1/8" and 6-1/4"
  • Designer Series Paper: 3-5/8" x 5"
  • Whisper White: 3-3/4" x 5" plus scraps for leaves
  • Powder Pink: 3-1/4" x 3-1/4"
Instructions:
  1. Fold base card on scored lines, adhere the DSP to the center front of the card.
  2. Using the largest of the Square Framelits place on base card center top, run through Big Shot. Punch above cut square with circle punch on top edge of the card.
  3. Place Tear & Tape on the inside edge of right panel, it will fold over the left panel to close the back of the card. Place 2" of tape on bottom edge. Close to create pocket.
  4. Cut Powder Pink square to create shutter. Place wax paper between the die and the cardstock and run through the Big Shot using the sandwich on page 215 in the catty. Brush out small pieces of cardstock using the Die Brush to create shutter.
  5. Adhere the Powder Pink shutter to the card using Multipurpose Glue.
  6. Stamp the hummingbird on Whisper White as follows ~ Use the bird stamp with the beak, stamp in Garden Green. Stamp bird without the beak over the first bird using Pear Pizzazz. Carefully line up bottom two lines of second bird between the bottom Garden Green lines and check the orientation of the head before stamping. It is hard to get a 'perfect' bird so put the white card in the shutter pocket to see how it looks ~ how the bird flies ~ he may be just fine.
  7. Stamp the leaves twice, once in Garden Green and once in Old Olive, cut out with leaf die and adhere on corner of card. Use Dimensionals on the top leaf. 


Want to re-create this project at home? Here's what you'll need to gather! Please feel free to click on any image below to go to my online stamp store and Shop with Debbie!
 
CLICK TO SHOP - Product List


Here is a video Stampin' Up! creating showing how this bundle works:




If you have any questions or would like to place an order, please email me and I will respond right away.

I appreciate each and every one of you and look forward to hearing from you.

Thanks for visiting and see you next time!


~Debbie







Tuesday, July 4, 2017

Coffee Cafe Thanks Project Sheet

Coffee Café Thanks


All images © 1990-2017 Stampin’ Up!®
Supplies:
  • Stamps: Coffee Café (143677) or Coffee Café Bundle (145331)
  • Paper: Coffee Break Designer Series Paper (144155), Early Espresso (119686), Whisper White (100730), Garden Green (102584)
  • Ink: Early Espresso (126974), Garden Green (126973)
  • Accessories: Corrugated Elements (144158), Coffee Cups Framelits (143745), Soft Sky 3/8” Classic Weave Ribbon (144160), Big Shot Die Cutting Machine (143263), Stampin’ Dimensionals (104430)
Measurements:
  • Early Espresso Card Base: 4-1/4” X 11”; score at 5-1/2”
  • 2 Pieces Designer Paper: 2” X 4-1/4”
  • Whisper White (for inside): 5-1/4” X 4”
Instructions:
  1. Stamp the coffee cup outline in Early Espresso on Whisper White cardstock. Cut out using the coordinating Framelit from the Coffee Cups Framelits.
  2. Cut out the “lid” and the cup “sleeve” using the Coffee Cups Framelits from Early Espresso cardstock.
  3. Stamp the “Thanks a Latte” sentiment in Garden Green ink on Whisper White cardstock. Cut out using coordinating Framelit. Adhere this piece to the corrugated elements oval piece.
  4. Stamp the little heart in Garden Green on Garden Green cardstock. Cut out using the coordinating Framelit.
  5. Adhere all the coffee cup pieces together.
  6. Stamp the coffee beans image randomly on the front of the Early Espresso card base.
  7. Adhere the two pieces of designer series paper to the front.
  8. Wrap the Soft Sky ribbon around the card and tie in a bow on the front.
  9. Adhere the coffee cup using Dimensionals to the front of the card.
Want to re-create this project at home? Here's what you'll need to gather! Please feel free to click on any image below to go to my online stamp store and Shop with Debbie

CLICK TO SHOP - Product List


If you have any questions or would like to place an order, please email me and I will respond right away.

I appreciate each and every one of you and look forward to hearing from you.

Thanks for visiting and see you next time!

~Debbie